Power-jacks C-Series Manual de usuario Pagina 21
- Pagina / 40
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
www.powerjacks.com
21
6
Maintenance
6.1 General Maintenance Notes
6.1.1 Maintenance and replacement work must be done by an expert maintenance technicians trained
in the observance of applicable laws on health and safety at work and the special ambient
problems attendant on the installation.
6.1.2 Before doing any work on the unit, the operator must rst switch off power to the screw jacks
drive system and ensure that it is out of service, as well as taking all necessary precautions
against it being accidentally switched on again or its parts moving without warning.
6.1.3 All additional environmental safety precautions must be taken (e.g. elimination of residual gas
or dust, etc.).
6.1.4 Before doing any maintenance work, activate all safety equipment and, if necessary, inform
persons working in the vicinity. In particular, mark off the area around the unit(s) and prevent
access to any equipment, which, if activated, might be the cause of unexpected health and safety
hazards.
6.1.5 Replace worn components with original spare parts only.
6.1.6 Use the lubricants (oil and grease) recommended by the Manufacturer.
6.1.7 When working on the units, always replace gaskets and seals with new original ones.
6.1.8 If a bearing requires replacement, it is good practice to also replace the other bearing
supporting the same shaft.
6.1.9 Power Jacks recommend replacing the lubricant after all maintenance work where a unit has
been dismantled (completely or partially).
6.1.10 The above instructions are aimed at ensuring efcient and safe operation of the C-Series screw
jack unit.
6.1.11 The Manufacturer declines all liability for injury and damage to components due to the use of
non-original spare parts and non-routine work, which modies the safety requirements without
the express prior authorisation of the Manufacturer.
6.1.12 Refer to the specic spare parts list when ordering spare parts for products.
6.1.13 Do not dump polluting liquids, worn parts and maintenance waste into the environment. Dispose
of all such materials as stipulated by applicable legislation.
- MAINTENANCE MANUAL 1
- C-Series 1
- Contents 3
- Introduction 4
- Product Code 8
- Standard Performance 9
- Installation4 10
- Installation 11
- Operation 15
- 5 Operation 16
- Operation5 18
- Maintenance 21
- 6 Maintenance 22
- 7 Recommended Lubricants 26
- Spare Parts 27
- 9 Storage & Warehousing 28
- Disposal of Units 29
- Warranty 30
- 12.1 Parts List 31
- 12.2 Rotating 32
- 12.3 Translating 33
- DESIGN WITH POWER 40
Relacionado con productos y manuales para Herramientas Power-jacks C-Series
(10 paginas)
(52 paginas)Craftsman 113.232240 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Nie Craftsman 113.232240.
Dostarczamy 1 pdf podręczników Craftsman 113.232240 do pobrania za darmo według typów dokumentów: Dokumentacja
Comentarios a estos manuales